Stress Gauging Locations
All hydraulic fluid power systems could at some time require troubleshooting, and the most important first step in troubleshooting is to take strain measurements in varied elements of the circuit. When constructing the system, slightly forethought in providing gauge points will save a lot of time and trouble if troubleshooting ought to be required.
Fittings and flanges are required in nearly every set up job as an intermediate joint between the pump, valve or actuator port to a different part in the system. A simple cylinder circuit may require SAE Code 61 flanges at the pump to affix its ports to the suction and strain hoses. The strain hose would possibly then terminate on the directional valve, the place it makes use of a JIC to NPT adapter to hitch the hose to stated valve. Lastly, NPT to JIC adapters at the work ports might feed hoses to a cylinder using SAE O-Ring boss ports fitted with 90° JIC to ORB adapters. Hydraulic fittings and flanges are merely unavoidable.
We’re a stocking distributor of RYCO hose products from 1/4″ 2 wire as much as 2″ six wire hose and fittings. This allows us to suit each hose earlier than it is installed on your gear for a neat and professional looking finish with a world quality product. Stocking 1000’s of hydraulic seals in standard and metric allows us to reseal cylinders quickly and successfully, many the same day, most inside 24 hrs. For these bigger than common cylinders, our cylinder desk has over 30,000 ft-lbs of torque and potential to clamp onto a 10″ nut. Now we have had clients combat bigger piston nuts for days with a number of men engaged on it only to bring it to us to break loose in 15minutes.