Measuring Oil Temperature
To measure temperature of the oil in a hydraulic reservoir, an strange sweet thermometer can be inserted through the filler opening after eradicating the protecting display screen, if any. Or by way of any other access gap which could also be out there. To stop entry of dirt, the entry gap should not be left open any longer than necessary.
R7 Simulation Tester is designed for pressure gauge adaptor LRRS (Lifeboat Launch & Retrieval system) to perform on-load and off-load test. The gear lifts up lifeboat by hydraulic power and takes over lifeboat weight. The operating personnel can pull the discharge handle to turn the release hook to open situation to check the operate of the gear.
Installation Method 1 (The normal means):
1. Clamp the hose finish in a vise with delicate jaws. To forestall straight hose ends from spinning, screw it onto a male AN fitting first.
2. Lube the barb with clean motor oil.
3. Slide the Oetiker clamp(s) onto the hose.
4. Warm the tip of the hose in boiling water for 5 to 10 seconds. This makes the rubber more pliable.
5. Slide the hose over the barbed fitting with a twisting motion.
6. Install Oetiker clamp(s).