Measuring Oil Temperature
To measure temperature of the oil in a hydraulic quick coupler reservoir, an unusual candy thermometer could be inserted via the filler opening after eradicating the protecting display, if any. Or through any other access hole which may be available. To prevent entry of dirt, the access gap shouldn’t be left open any longer than obligatory.
R7 Simulation Tester is designed for LRRS (Lifeboat Launch & Retrieval system) to perform on-load and off-load test. The gear lifts up lifeboat by hydraulic energy and takes over lifeboat weight. The working personnel can pull the release handle to turn the discharge hook to open condition to examine the function of the gear.
Set up Methodology 1 (The normal means):
1. Clamp the hose finish in a vise with soft jaws. To stop straight hose ends from spinning, screw it onto a male AN fitting first.
2. Lube the barb with clean motor oil.
3. Slide the Oetiker clamp(s) onto the hose.
4. Warm the top of the hose in boiling water for 5 to 10 seconds. This makes the rubber extra pliable.
5. Slide the hose over the barbed fitting with a twisting movement.
6. Install Oetiker clamp(s).