BEFORE YOU BEGIN:
1) This product is specifically designed for set up on the outside of the vehicle.
2) Required Items include an installation squeegee, zgripceanu01 masking tape, glass cleaner, dry paper towels, measuring tape or ruler.
three) Don’t apply any vinyl graphics in direct sunlight. Make certain it is between 60 degrees and 80 degrees F. Park the vehicle in the garage within the shade. Let cool for 30 minutes if hot.
4) Don’t store unapplied graphics in direct sunlight – damage might occur.
5) All dust, grease and wax must be removed from the automobile surface before the decal is applied. This includes wax from mechanical car washes, rain-x, compound, etc. Failure to take this step might consequence in the decal not sticking to the vehicle surface.
STEP 1 – UNPACK THE SHIPPING CONTAINER – Remove decals from packaging. Lay decals flat on a smooth table in an space that’s a minimum of 60° F and under 80° F.
STEP 2 – PREPARE THE SURFACE – Crucial step throughout decal set up is making sure the installation space is clean and dry. Make certain there may be NO WAX, RAIN-X, COMPOUND, lint, dust, or other residue on the surface. Remove all wax, compound residue, automotive wash protestants, etc with rubbing or denatured alcohol. After cleaning the surface, go over the surface with common glass cleaner.
STEP three – FIND DESIRED LOCATION OF THE STRIPES – Using a string or other line, place it over the vehicle from the entrance to the back within the desired location for the stripes. Make certain that the string is symmetrically centered on the vehicle. Mark this location with a pencil of different nonpermanent marking machine at the front and the rear of every body panel. This will function the placement of the edge of the stripes.
STEP four – PLACE THE STRIPES – Measure the length of each body panel to which the stripe is to be applied. Lay the stripe section over the area of the vehicle, trimming the excess stripe off one finish (leave not less than an inch additional) Save all cut off items, as they can be utilized to cover bumpers and fins.
STEP 5 – SECURE THE STRIPES – Place a strip of masking tape at one end of the stripe, as this will hold the tip of the stripe while installing. Working from that end to the other, slowly peel back the discharge paper half of way down and spray the body surface with a fine mist of water answer (not soapy solution). With a squeegee, apply the stripe to the body panel working from the middle of the stripe outward. As you work further down the stripe, slowly proceed to remove the backing paper as needed. Slowly continue to apply the stripe with the squeegee, applying even pressure across the width of the stripe.
STEP 6 – REMOVE THE TRANSFER PAPER – As soon as the whole piece is utilized, remove the masking tape from the tip of the stripe. Next remove the transfer tape covering, careabsolutely pulling parallel to the surface of the vehicle (NOT UP BUT SIDEWAYS).
STEP 7 – FINISH INSTALLATION – Any small air pockets will be simply removed by first placing a small hole within the bubble (small hole, not giant slice). Then moisten the squeegee edge with water and slide the squeegee alongside the surface of the stripe the place the bubble is, working the air towards the hole.
CARE AND MAINTENANCE:
Once the decal is put in, to keep it looking new, merely wash it whenever you wash the vehicle. You’ll be able to apply automobile wax, clearcoat, or RainEx over the decal as soon as it is applied. your new decal will give you years of great looks. If you are in cold local weather be careful when utilizing an ice scraper on any surface where decals are applied.