Stress Gauging Areas
All hydraulic fluid power methods may at a while require troubleshooting, and the most important first step in troubleshooting is to take pressure measurements in varied components of the circuit. When constructing the system, slightly forethought in providing gauge factors will save lots of time and hassle if troubleshooting must be required.
Fittings and flanges are required in nearly each installation job as an intermediate joint between the pump, valve or actuator port to a different component in the system. A easy cylinder circuit might require SAE Code 61 flanges at the pump to hitch its ports to the suction and pressure hoses. The stress hose might then terminate on the directional valve, where it uses a JIC to NPT adapter to join the hose to mentioned valve. Lastly, NPT to JIC adapters at the work ports might feed hoses to a cylinder using SAE O-Ring boss ports fitted with 90° JIC to ORB adapters. Hydraulic fittings and flanges are merely unavoidable.
We are a stocking distributor of RYCO hose merchandise from 1/4″ 2 wire up to 2″ six wire hose and fittings. This permits us to fit every hose earlier than it’s installed in your equipment for a neat and professional trying end with a world quality product. Stocking 1000’s of hydraulic seals in customary and metric allows us to reseal cylinders rapidly and successfully, many the same day, most inside 24 hrs. For those larger than average cylinders, our cylinder desk has over 30,000 ft-lbs of torque and capability to clamp onto a 10″ nut. We’ve got had clients fight bigger piston nuts for days with a number of men working on it solely to convey it to us to interrupt unfastened in 15minutes.