Stress Gauging Locations
All hydraulic fluid energy techniques may at some time require troubleshooting, and a very powerful first step in troubleshooting is to take stress measurements in numerous components of the circuit. When constructing the system, a little forethought in providing gauge factors will save loads of time and hassle if troubleshooting needs to be required.
Fittings and flanges are required in practically every set up job as an intermediate joint between the pump, valve or actuator port to a different component in the system. A easy cylinder circuit may require SAE Code 61 flanges on the pump to hitch its ports to the suction and stress hoses. The stress hose may then terminate on the directional valve, the place it uses a JIC to NPT adapter to hitch the hose to mentioned valve. Finally, NPT to JIC adapters on the work ports would possibly feed hoses to a cylinder employing SAE O-Ring boss ports fitted with 90° JIC to ORB adapters. hydraulic test point fittings and flanges are merely unavoidable.
We’re a stocking distributor of RYCO hose products from 1/4″ 2 wire up to 2″ six wire hose and fittings. This allows us to fit each hose earlier than it’s installed on your gear for a neat and professional looking end with a world quality product. Stocking 1000’s of hydraulic seals in normal and metric permits us to reseal cylinders quickly and successfully, many the identical day, most inside 24 hrs. For those larger than common cylinders, our cylinder table has over 30,000 ft-lbs of torque and skill to clamp onto a 10″ nut. We now have had clients struggle larger piston nuts for days with multiple males working on it solely to convey it to us to interrupt unfastened in 15minutes.